Most roof warranties are voided by things the homeowner never thought of as a problem: a satellite installer’s lag bolts, a pressure-washing company, a handyman’s patch, insulation that buried the soffit vents. The manufacturer’s warranty covers defects in the shingle, and its conditions are written to exclude anything that could have caused the failure instead. Here is the list that matters for a Tyler roof, and how to stay on the right side of it.
Inadequate attic ventilation
The first thing a manufacturer checks on a warranty claim. Shingles over a hot, unventilated attic age early, and the warranty requires ventilation that meets the building code’s minimum. Soffit vents blocked by insulation, a ridge vent with no intake, or an attic fan fighting a ridge vent can all be cited. Advantage checks and corrects ventilation when we replace a roof, and we photograph it for your file.
Installation that does not follow the instructions
High nails, too few nails, missing starter strip, no drip edge, wrong underlayment, shingles installed over a wet deck. Manufacturers will deny a material claim when the failure traces to installation, which is why the contractor’s workmanship warranty exists and why the contractor’s certification matters. A roof installed by an Owens Corning Platinum Preferred contractor under a system warranty carries manufacturer-backed workmanship coverage; a roof installed by an uncertified crew does not.
Pressure washing and harsh cleaning
Pressure washing strips granules off shingles and drives water under them. It voids most shingle warranties outright. Algae streaks on a shaded Tyler roof are cleaned with a low-pressure wash using cleaners the manufacturer approves, or prevented with zinc or copper strips at the ridge. Say no to anyone who shows up with a pressure washer.
Unapproved repairs and modifications
Repairs by someone other than a qualified roofer, or with incompatible materials, can void coverage for the affected area and sometimes the whole roof. Common offenders:
- Satellite dishes and antennas bolted through the shingles.
- Solar mounts installed without flashed, sealed attachments.
- Holiday light clips that pierce or lift shingles, or decorations screwed to the roof.
- Caulk smeared over a leak by a handyman.
- A second layer of shingles installed over the first, which some manufacturers exclude.
- Paint or coatings not approved for the shingle.
Foot traffic and other damage
Walking on a roof, especially in heat when shingles are soft or in cold when they are brittle, scuffs granules and cracks mats. HVAC technicians, painters and gutter installers all walk roofs. Damage from traffic, storms, falling limbs or animals is not a defect and is not covered by the manufacturer; it is an insurance or repair matter.
Failure to register or transfer
Many enhanced warranties require registration with the manufacturer within a set period after installation. Advantage registers the system warranties we sell and gives you the confirmation. When a home is sold, most warranties allow one transfer within a window after the sale; miss it and the new owner has reduced or no coverage.
Changing the roof’s environment
Adding spray foam to the underside of the deck, closing off ventilation, or installing a radiant barrier incorrectly changes the conditions the shingle was warranted for. Some manufacturers have specific terms for unvented assemblies; check before you change the attic.
What does not void a warranty
- A storm claim and replacement by a different contractor on the damaged slopes, if done to spec.
- Shingle Rx treatment on an aging roof, which is applied to roofs typically already past the non-prorated period; we will review any warranty you still hold first.
- Gutter guards installed correctly under the drip edge without lifting shingles.
Keeping the workmanship warranty too
The contractor’s warranty has its own conditions: usually that the roof is not altered by others, that problems are reported promptly, and that the original owner holds the home. Advantage’s lifetime workmanship warranty on qualifying installations asks the same, and we keep every installation’s photos on file so a claim years later is simple.
Keep a roof file
Put the estimate, the invoice, the warranty registrations, the installation photos and every subsequent repair or inspection report in one folder. When a manufacturer asks what happened to a roof, that folder answers. Advantage provides all of it at the end of every Tyler installation. Questions about an existing warranty? Call (903) 939-3168 or schedule a free inspection.